ERBAUER 254MM (10”) DOUBLE BEVEL SLIDING MITRE SAW
Caution:
If the saw has not been used recently,
recheck blade squareness to the fence and readjust
if needed.
5) After fence has been aligned, using a scrap piece
of wood, make a cut and check
‘squareness’ of the cut in the piece. Readjust if
necessary.
10. Setting cutting depth
The depth of cut can be preset for even and
repetitive shallow cuts.
1) Adjust the cutting head down (See CUTTING
HEAD Section) until the teeth of the blade are at the
desired depth.
2) While holding the upper arm in that position, turn
the stop knob (1) until it touches the stop plate (2).
3) Recheck the blade depth by moving the cutting
head front to back through the full motion of a
typical cut along the control arm. (See ig. 26)
11. Adjusting cutting depth
The maximum depth travel of the cutting head was
set at the factory. Check to see that the blade does
not extend more than 6.35 mm below the table
insert, and does not touch the control arm throat or
any part of the base or table. If the maximum depth
needs readjusting:
1) Loosen the depth control screw locknut (3).
2) Pull the cutting head down until it indexes with the
depth control screw.
3) Adjust the depth control screw until the blade extends
6.35mm below the table insert.
4) Recheck the blade depth by moving the cutting
head front to back through the full motion of a cut
along the control arm. If the blade touches the inside
of the control arm, readjust the setting. Tighten the
locknut when the correct setting is achieved. (See
ig. 26)
Fig 26
1
3
2
Fig 25
1
2
3
1
