ERBAUER 254MM (10”) DOUBLE BEVEL SLIDING MITRE SAW
6. Mounting the mitre saw
WARNING!
To avoid injury from unexpected
saw movement:
• Switch off and unplug from power, and lock the
cutting head in the lower position using the stop latch.
• Lock the slide carriage in place by tightening the
slide carriage lock knob.
• To avoid back injury, lift the saw by using the
designated carrying handles located on the top of
the machine. When lifting, bend at your knees, not
from your back.
• Never carry the mitre saw by the power cord or by
the switch handle. Carrying the tool by the power
cord could cause damage to the insulation or the
wire connections resulting in electric shock or ire.
• To avoid injury from lying debris, do not allow
visitors to stand near the saw during any cutting
operation.
• Support the saw on a level work surface.
• Bolt or clamp the saw to its support.
Mounting instructions
1) For stationary use, place the saw in the desired
location, directly on a workbench where there
is room for handling and proper support of
the workpiece. The base of the saw has four
mounting holes. Bolt the base of the mitre saw
(1) to the work surface (5),using the fastening
method as shown in Fig. 9.
2) For portable use, place the saw on a
20mm(approx) thick piece of plywood. Bolt the
base of the mitre saw securely to the plywood
using the mounting holes on the base. Use
G-clamps to clamp this mounting board to a stable
work surface at the worksite. (See ig. 10)
Note:
Mounting hardware is
not included
with this tool. Bolts, nuts, washers and
screws must be purchased separately.
Fig 10
Fig 9
1) Hex headed bolt
2) Spring washer
3) Flat washer
4) Mitre saw base
5) Workbench
6) Flat washer
7) Spring washer
8) Hex nut
9) Lock nut
1
2
3
4
5
6
7
8
9
