ERBAUER 254MM (10”) DOUBLE BEVEL SLIDING MITRE SAW
ADJUSTMENT INSTRUCTIONS
1. Bevel stop adjustment
WARNING!
To avoid injury from an
accidental start, make sure the switch is in
the OFF position and the plug is not connected to
the power source socket.
2. 90° (0°) Bevel adjustment
1) Loosen bevel lock handle (1) and rotate the cutting
arm completely to the right until it stops against the
vertical stop. Tighten the bevel lock handle.
2) Place a combination square (2) on the mitre table
with the ruler against the table and the heel of the
square against the saw blade.
3) If the blade is not 90
°
(0
°
) square with the mitre
table (5), loosen the bevel lock handle (1), tilt the
cutting head to the left, loosen the locknut (4) on the
bevel angle adjustment bolt (3) and use an allen key
to adjust the socket headed stop bolt (3) depth in or
out to increase or decrease the
bevel angle.
4) Tilt the cutting arm to back to the right at 90
°
(0
°
)
bevel and recheck for alignment.
5) Repeat steps 1 through 4 if further adjustment is
needed.
6) Tighten bevel lock handle (1) and locknut (4)
when alignment is achieved.
(See ig. 19)
Fig 19
2
5
4
3
1
