ERBAUER 254MM (10”) DOUBLE BEVEL SLIDING MITRE SAW
ASSEMBLY INSTRUCTIONS
WARNING!
To avoid injury, do not
connect this mitre saw to the power
source until it is completely assembled and adjusted
and you have read and understood this Operator’s
Manual.
1. Installing the mitre handle
1) Thread the mitre handle (1) into the hole located
at the front of the mitre table. (See ig. 3)
2. Unlocking the slide carriage
After removing the saw from the carton, loosen
the slide carriage lock knob (1). When transporting
or storing the mitre saw, the slide carriage should
always be locked in position. The slide carriage lock
knob (1) is located on the side of the slide carriage.
(See ig. 4)
3. Raising the Cutting Head
1) Push down slightly on the switch handle (1)
and the lock lever (2).
2) Pull out the stop latch knob (3).
3) Allow the cutting head to rise to the up position.
(See ig. 5)
WARNING!
To avoid injury and damage
to the saw, transport and store the mitre
saw with the cutting head locked in the down
position. Never use the stop latch to hold the cutting
head in a down position for cutting operations.
Locking
When transporting or storing the mitre saw, the cutting
head should always be locked in the down position.
1) Push the lock lever (2) and cutting head down to
its lowest position.
2) Push the stop latch knob (3) into the locking hole.
IMPORTANT
To avoid damage, never carry the mitre saw by the
cutting arm or the mitre handle. ALWAYS use both
designated carrying handles together.
Fig 4
Fig 5
1
1
2
3
Fig 3
1
