Equipment Zone Fast T-Jet 3, User Manual

Page: 90 / 145

76
Finish with Fast T-Jet Non-Textile Post-Treatment
Fast T-Jet Non-Textile Post-Treatment is a protective coating used for prints on
non-textile surfaces. This post treatment will prevent fading of ink colors, extend
the life of the image as well as waterproofing and acting as a UV protectant.
DIRECTIONS:
Shake the can before each use and apply to non-textile, printed
surfaces only after all ink has dried thoroughly. Apply a thin coat,
holding the can 4 to 8 inches from surface and using a swift motion
to prevent overspray and unwanted build-up. If build-up does
occur, use a lacquer thinner to remove. A second coat may be
applied after approximately two minutes of drying time. Allow
treated surfaces to dry for 30 minutes to one hour in a clean, dust
free area before handling. Allow 24 hours cure time prior to placing
coated articles into service.
Clean the valve after use by turning the can upside down and spraying a
short burst until cleared. If the nozzle is clogged or sprays irregularly, check for
clogging within the opening. Scrape off excess coating with a soft object and
twist the valve one half turn to close.
Non-Textile Printing Tips
When brushing on any of the treatments, make sure they are applied in o
smooth, even and thin layers.
Having two brushes can make the pretreatment and priming processes
o
easier. Use one for Non-Textile Primer and one for Non-Textile Pretreatment.
Cleaning the brushes when done with hot water and letting dry will prevent
o
them from drying out and ruining the brushes.
When printing on Non-Textile items, use a piece of film that covers the whole o
item and print a test print to see if it is aligned with the desired printing area.
The maximum printable area of a Fast T-Jet 3 is 13” x 22”. To maximize
o
production, you can position multiple items next to each other to print more
then one item at a time.
If you have a Heat Press, you may dry items faster by placing them under
o
the element, but you MUST avoid contact between the item and the heated
surface.
Fast T-Jet 3 User’s Manual