162
LCD screen message
Condition/solution
Maintenance Request
Replace Part
Soon/Replace Part Now
(maintenance request
code)
A part used in the printer is nearing the end of its service life. Contact Epson
for support and provide them with the displayed maintenance request code.
The error persists until you replace the requested part.
Call For Service
(service code)
Power off and then on. If
this doesn't work, note
the code and call for
service.
A call for service occurs when:
• The power cable is not connected securely
• An error occurs that cannot be cleared
When a call for service occurs, the printer automatically stops printing. Turn
off the printer, disconnect the power cable from both the outlet and the
printer, and then reconnect them. Turn the printer on and off several times. If
the same call for service is displayed on the LCD screen, contact Epson for
support and provide them with the displayed service code.
Status Icons
Icons
Description
Printer temperature alert Displayed when the temperature around the print head exceeds 86
˚
F (30
˚
C). If you continue to use the printer while this icon is displayed, the
frequency of automatic cleanings increases. Reduce the room temperature
or temporarily stop printing to reduce the temperature around the print head.
Note:
Automatic cleaning is performed by the printer at a defined interval to
keep the print head in good condition.
Summary of Contents for SureColor F2100 Series
