Problem
Solution
Using the pull
tractor with the
push tractor,
continuous paper
does not feed
properly
(continued).
Skip over perforation is
set, but the skip has
shifted from the
perforation, or the
perforation does not
fall in the center of the
skip.
When the printing
ends the paper feeds
abruptly, and as it
resumes printing, the
paper feeds backward
and comes off the pull
tractor sprockets.
When the
LOAD/EJECT
button is pressed to
eject the paper, the
paper comes off the pull
tractor sprockets.
The page length for one page of the
continuous paper may be set incorrectly.
Use DIP switches 2-1 and 2-2. See
Chapter 3. You can use control codes
ESC C or ESC C 0 to set the correct page
length. See Chapter 9.
The loading position of the paper may be
too high or too low. Use the micro-
adjustment feature to reset the loading
position. See Chapter 3.
The short tear-off function may be
selected. The
short
tear-off function
cannot
be used with the pull tractor, so be
sure to set DIP switch 2-7 to off. See
Chapter 3.
When the paper release lever is in the
continuous paper position, the paper
feeds backward to eject. When using the
pull tractor, press the
FORM FEED
button
to feed the paper forward to eject. See
Chapter 5.
7-34
Troubleshooting
Summary of Contents for LQ-1050
