58
Appendix J
NOTES ON PRINTING AND BACKFEED
1)
If top margin specification via backfeed (3.5.2 (2)) is enabled, the backfeed operation is performed before
starting printing directly after the autocut. If top eject, this backfeed operation is performed after the paper
in the eject port is removed.
2)
If enabling the top margin specification via backfeed (3.5.2 (2)), we recommend disabling the auto top logo
printing (3.5.2 (6)). Backfeeding a paper that uses top logo printing can often cause paper jams.
3)
Even if top margin specification via backfeed (3.5.2 (2)) is enabled, the backfeed is not performed in the
following cases.
Backfeeding directly after autocutting of roll paper when the roll paper cover is closed
Backfeeding during the self-test
4)
When backfeeding is performed, slack in paper can cause wrinkles and friction marks. Check with the user
before using. If you wish to prevent friction marks, use thermal paper that has high resistance to abrasion.
5)
Perform autocutter operation after feeding paper a minimum of 20 mm.
(This is to prevent small pieces of cut paper from dropping into the autocutter and causing paper jams.)
Summary of Contents for EU-m30 Series
