30
Table 3.5.2 Memory Switch 5 (Msw5)
Msw
Function
Setting value
Factory
setting
48 (OFF)
49 (ON)
5-1 USB power-saving function *1
Enabled
Disabled
48 (OFF)
5-2 (Reserved)
–
–
48 (OFF)
5-3 Paper sensors to output paper end
signal
Roll paper end, near-
end sensor enabled
Disabled
48 (OFF)
5-4 Error signal output
Enabled
Disabled
48 (OFF)
5-5 Pre-feed before next print
*2
Disabled
Enabled
48 (OFF)
*3
5-6 Roll paper near-end sensor
Disabled
Enabled
4
9
(O
N
)
5-7 (Reserved)
–
–
48 (OFF)
5-8 (Undefined)
–
–
48 (OFF)
*1:
Valid only when the USB interface communication condition is set to the vendor-defined class and the
system configuration is set so that the USB driver can support the USB power-saving function.
*2:
When a customized value (specification for the top margin by backfeed) is set and back feed occurs, this
setting is disabled.
*3:
Japanese model only, default setting 49 (ON).
(2)
Customized value setting
Can be changed using one of the following methods.
(a) User setup commands: GS ( E
Step 1:
Moves to the user setting mode with GS ( E <Function 1>
Step 2:
Change the setting with GS ( E <Function 5>.
Step 3:
End the user setting mode with GS ( E <Function 2>.
For details, see "ESC/POS Command Reference" (
www.epson-biz.com/pos/reference/
(b) Software setting mode (except some functions)
For details, see 3.8.3 Software setting mode.
(c) EU-m30 Utility (except some functions)
Table 3.5.3 Types of Customized Values
Function
Selectable values
Factory setting
NV user memory capacity
1 KB, 64 KB, 128 KB, 192 KB
1 KB
NV graphics memory capacity
None, 64 KB, 128 KB, 192 KB, 256 KB,
320 KB, 384KB
384 KB
Roll paper width *2
80 mm {3.15"}, 58 mm {2.28"}
80 mm {3.15"}
Print density
70 to 130% (In 5% units)
100%
Print speed
Level 1 to 13 (Low speed to high
speed)
Level 13
Thai character print mode
Thai 1 pass / Thai 3 pass
Thai 1 pass
Default character code table
43 pages selectable with ESC t
0
Default international character
18 types selectable with ESC R
0
Summary of Contents for EU-m30 Series
