Epson Endeavor Pro, User Manual

Page: 34 / 187

System Setup options (continued)
* Default setting
(1) If you installed a video adapter card, make sure you disable the
on-board SVGA controller by setting jumper JP2 to position 2-3; see
“Changing the Jumper Settings” in Chapter 4 for instructions.
(2) If the System
memory
and
Extended memory
values are not correct,
check that the SlMMs are installed correctly, as described in “Installing
Memory Modules (SIMMs)” in Chapter 4.
Using the Fixed Disk Setup Option
The Fixed Disk Setup option defines the types of hard
disk drives connected to the primary and secondary IDE
interfaces in your system. When you select this option, you see
the Fixed Disk Setup screen.
Note
These options do not configure other IDE devices, such as
CD-ROM drives, connected to the secondary IDE interface.
Fixed Disk Setup screen options
Make sure the Large Disk Access Mode option is set to
DOS (the default setting). Set this option to Other if you are
using UNIP or an operating system other than MS-DOS@ or
Windows.
Running SETUP and Installing Drivers 2 - 5