Epson Endeavor Pro, User Manual

Page: 26 / 187

You may also need to change the setting of the LPT Port
option in SETUP if you need a different address and /or
interrupt assignment for the port.
Note
If you use ECP (Extended Capabilities Port) mode, you may
also need to change jumpers JP8 and JP9 to the correct DMA
channel; check your parallel device documentation for the
DMA channel you should use. Then see “Changing the
Jumper Settings” in Chapter 4 for instructions on setting
jumpers.
Using
the
serial
ports
If you have a printer, a modem, or other device with a serial
interface, you can
connect
it to one of the serial (RS-232C) ports.
Make sure you have a cable compatible with a DE9P connector.
To
connect
a serial device, insert the connector into
either the serial 1 or serial 2 port. If you are connecting
only one serial device, use the serial 1 port.
Connectting the Power Cord
Follow these steps to connect the computer’s power cord:
1. Plug the power cord into the power inlet on the back of the
computer.
power inlet
AC outlet
voltage selector witch
l - 8 Setting Up Your System