4.
Reach behind the drive and gently push it out through the
front of the bay; then pull it out of the slot.
5.
Once you have removed the drive, you may want to replace
the plastic faceplate by inserting one side of the plate, then
gently pressing on the other side until it snaps into place.
6.
If you removed the only IDE device connected to the
interface the device used, you can disconnect the device
cable from the main system board and remove it from the
computer.
7.
Replace the drive mounting bracket; see “Replacing the
Bracket in the Computer” for instructions.
8.
If you have finished installing or removing drives, replace
the computer’s cover; see “Replacing the Cover” in
Chapter 4 for instructions. Then see “Running SETUP” in
Chapter 2 for instructions on defining your new drive
configuration.
Installing and Removing Drives in the Slimline Computer
5-21
Summary of Contents for Endeavor Pro
