Epson EH-TW570, User Manual

Page: 52 / 151

Connect the charging cable to the projector's USB-A port to charge the 3D
Glasses. (Only when the projector is on.)
Attention
•
Only connect to an electrical outlet that uses the voltage displayed on the
adapter.
•
Note the following points when handling the charging cable supplied with the
3D Glasses.
- Do not use the cable if it is damaged.
- Do not modify the cable.
- Do not bend, twist, or pull the cable with too much force.
- Do not position it near an electric heater.
a
The following shows the standard charging and usage times.
•
For a 3 minute charge, the usage time is approximately 3 hours.
•
For a 50 minute charge, the usage time is approximately 40 hours.
Registering the 3D Glasses to the projector (pairing)
When viewing 3D images, the projector communicates with the 3D Glasses.
To communicate correctly, the 3D Glasses have to be registered to the
projector. This is known as "pairing".
Perform pairing in the following situations.
•
When turning on the 3D Glasses for the first time.
Pairing starts automatically when the power is turned on.
•
When you cannot view 3D images correctly.
Follow the steps below to perform pairing.
a
Turn on the projector.
b
Press the [Source Search] button on the control panel or the
remote control, and then select
HDMI .
c
Turn on the 3D Glasses by sliding the power switch to [On].
The indicator turns on for several seconds, and then turns off.
Projection Functions
52