EPSON LX-300+II/300+II RTP/1170II
Revision D
PRODUCT DESCRIPTION
Interface Specifications
21
1.3.3 Serial Interface
Synchronization:
Asynchronous
Signal level:
EIA-232D
MARK (logical 1):
-3V to -25V
SPACE (logical 0):
+3V to +25V
Word length:
Start bit:
1 bit
Data bit:
8 bits, 7 bits
Parity bit:
Odd, Even, Non, Ignore
Stop bit:
1 bit or more
Baud rate:
300, 600, 1200, 2400, 4800, 9600 or 19200 bps
Handshaking:
DTR signal and XON/XOFF
DTR=MAEK, XOFF:indicates that the printer cannot
receive data.
DTR=SPACE, XON: indicates that the printer is ready
to receive data.
NOTE:
The DTR signal is MARK and XOFF code (DC3, 13H) is transmitted
when the rest of the input buffer becomes 256 bytes. The DTR signal is
SPACE and XON code (DC1, 11H) is transmitted when the rest of the
input buffer is regained 256 byte.
Error handling:
Parity error is only detected. Overrun error and framing
error are ignored.
Connector:
25 pin subminiature D-shell connector (female)
NOTE:
In/Out shows the direction of signal flow as viewed from the printer.
Table 1-18. Connector Pin Assignment and Signals
Pin
No.
Signal Name
In/Out
Functional Description
2
TXD
Out
Transmit data.
20
DTR
Out
Indicates that the printer is ready to receive data or not.
11
REV
Out
Connected directly to the DTR signal.
4
RTS
Out
Request to send. Always SPACE level when the printer
is powered on. Pulled up to +12V via 4.7K
Ω
resistor.
3
RXD
In
Receive data.
7
Signal GND
--
Signal GND
1
Chassis GND
--
Chassis GND
other
NC
--
Not used. Not connected.
Summary of Contents for cLX-300+II RTP
