EPSON Stylus PHOTO 895/785EPX
Revision A
Disassembly and Assembly
Disassembly
104
C H E C K
P O I N T
Unlike the previous products, the oil pad is not built in the CR
unit.
If you disassemble the CR unit after removing the CR unit from
the printer, make sure that the CR Grounding plate is assembled
in the suitable position in the CR unit. Refer to Figure 4-58.
"Grounding plate assembling position".
Make sure that the CR slider is assembled on the CR unit.
Figure 4-58. Grounding plate assembling position
If you remove the Printhead from the CR unit, make sure that
the Head grounding plate is set in the CR unit. Refer to Figure
4-16. "Printhead installing the position pin & the grounding
plate".
CR Slider
CR Grounding Plate
C H E C K
P O I N T
If the CR unit is disassembled or replaced with a new one, make
sure that the CR timing belt is set in the assembling groove
correctly as following figure.
Figure 4-59. CR timing belt setting position
A D J U S T M E N T
R E Q U I R E D
When you replace the CR unit with a new one, lubricate it with
the suitable amount of the G-56 grease by the specified position.
Refer to Chapter 6 Figure 6-1. "Lubrication point 1".
When you replace the CR Pulley shaft with new one, lubricate it
with the suitable amount of G-26 grease by the specific position.
Refer to Chapter 6 Refer to Figure 6-3. "Lubrication point 3".
When removing or replacing the CR unit with a new one, adjust
the Gap (Bi-d).
Assembling Groove
CR Timing Belt
