Epson 1815p - PowerLite XGA LCD Projector, User Manual

Page: 174 / 204

174
Solving Problems
■
If you’ve changed any settings for your projector or network, or
restarted your computer, allow a minute or two for the
connection to appear. If you’re using AirPort, try turning AirPort
off and then on again.
■
Make sure that you’re trying to connect to the right network. In
Windows, verify that you’ve enabled your computer’s connection
to the access point (see page 71) or that your wireless card or
adapter is enabled and its SSID is set to match the projector’s
ESSID (see page 63). On a Mac, click the AirPort icon at the top
of your Mac desktop to make sure AirPort is turned on and the
projector’s ESSID or your AirPort network is selected.
■
If you have an access point or AirPort base station and you’re not
using DHCP, check your projector’s IP address on the Access
Point mode advanced settings screen. The first three segments of
the IP address should be identical to the first three segments of the
IP address of your access point or base station. The last segment of
the projector’s IP address should be close, but not identical, to the
last segment of the IP address of the access point or base station.
■
If you’re not using DHCP, check your projector’s Gateway
address on the projector’s Access Point mode advanced settings
screen. It should be identical to the IP address for your access
point or AirPort base station.
■
If you’re using a projector keyword, it changes each time you turn
the projector off and then on again, or remove and reinsert the
wireless network module. Check the projector’s keyword on the
EasyMP Network screen and enter it at the prompt.
■
If you’re using AirPort, check the configuration of your network.
Start the AirPort Admin utility, select your base station, click
Configure
and click
Show All Settings
. Click the
Network
tab.
If you set up your projector to connect in DHCP mode, turn on
Distribute IP Addresses
and
Share a Single IP Address
.
■
If you’re using AirPort and DHCP is turned off on your
projector’s Access Point mode advanced settings screen, make sure
Distribute IP Addresses
is off.