Epson 1010, User Manual

Page: 191 / 279

Options
This section describes problems you may encounter while using the
optional cut sheet feeder or an optional interface board.
With the cut sheet feeder, paper does not feed properly.
l
When a print command is sent from the computer, the platen rotates,
but paper does not feed.
Make sure DIP switch 1-8 is on.
Make sure the cut sheet feeder is correctly installed on the
printer.
Check that the paper release lever is pushed back to the single
sheet position.
Make sure paper is loaded in the cut sheet feeder’s bin. If only
one sheet is left in the bin, add more paper.
l
Two or more sheets feed at the same time.
You may have loaded too many sheets in the cut sheet feeder’s
bin.
You may have forgotten to fan the stack of paper before loading
it into the bin. Remove the paper and fan it.
l
The paper feed is crooked.
The paper may be old or creased. Use only new, clean sheets of
paper.
Make sure that your paper is the proper size and quality.
l
One page of printing has spread to two pages.
Check that the page length setting is correct.
7-10
Troubleshooting