Entrust Artista CR875, Installation And Administrator'S Manual

Page: 92 / 150

82 Printer Manager

ColorMode —Select the color mode that best defines the color printing requirements for
your site. You can select from the following:

TrueColor (ICC). Uses a color profile that has been calibrated to closely match the output
produced by the Entrust Artista® VHD Retransfer Color Printing Module Gen 2.

Legacy SR/CR. Processes the input colors to provide print output that is similar to that
produced by Entrust SR200/SR300/CR500 card printers. The printed card will not be
identical because of differences in the print resolution and canvas size used by the CR825
or CE875 printer. You may need to modify your existing card designs to produce the
optimal output.

Legacy SR300 LUT. Processes the input colors to provide print output that is similar to
that produced by the Entrust SR300 card printer when it uses a color lookup table (LUT).

VIvid. Produces darker, more saturated color on the printed card. It is based on the
TrueColor (ICC) setting.

FilmPreregisterProcess —Sets the location of the retransfer film index mark at initialization
and at the end of a print job. Possible values are:

Original: The retransfer film index mark is positioned so that it does not block the film
sensor.

StopOnIndexMark: The retransfer film index mark is positioned so that it blocks the film
sensor. Primerless ribbon always uses the StopOnIndexMark value to reduce wrinkling in
the retransfer film.

SettingsGroupPurpose —State the purpose of a settings group. Group names are not
changeable. Use this option to identify the reason for creating a settings group.

TimeoutRewindSupply —Specify the number of minutes of idle time before the printer
rewinds the ink ribbon and retransfer film to protect them from dust. If the ribbon and
retransfer film are left exposed, a static charge on the supplies attracts dust from the air. The
printer rewinds the ink ribbon and retransfer film at the end of the specified time. The
supplies unwind again when the next card is sent to the printer. The default setting of zero (0)
minutes turns off the rewind process. The rewind does not occur if a job is running or the
printer door is open.
Contact your service provider for more information about when to use the supply rewind
feature and recommended settings.
Using the supply rewind feature can reduce the number of cards printed with a
ribbon.