Entrust Artista CR875, Installation And Administrator'S Manual

Page: 37 / 150

CR825 and CE875 Instant Issuance System Installation and Administrator’s Guide 27
5.
Replace the retransfer film cartridge in the printer.
6.
Close the printer access door.
7.
Continue with “Load Cards” .
Load Cards
Do the following to load cards in the input hopper. If you plan to insert cards in the exception slot,
make sure that blank cards are available near the printer.

Handle cards by the edges only, or wear card inspection gloves approved by Entrust.

Cards can stick together. Slide or fan the cards to separate the edges before placing them in
the input hopper.

Insert ISO magnetic stripe cards with the stripe (back side) facing down and to the right.

Insert smart cards with the smart card chip facing up and toward the back of the hopper.
Refer to “Cards” on page 114 for more information about card stock and card handling guidelines.
Single-Hopper Printer
1.
Open the input hopper door.
2.
Load the cards into the input hopper. The hopper can
hold up to 125 cards.
3.
Close and lock the input hopper.
A diagram inside the input hopper shows the correct orientation for each type of card.