12
Cover
The cover and back plate are manufactured in clear anodized aluminium. The end plates are made
of black painted steel sheet.
12.1
Fitting and removing the cover
The cover is slid over flanges in the back plate so that the ridges fit in the grooves.
Break off and snap on the fill cover into the back plate for output shaft. Snap on the other fill cover
for the second slot. Secure cover with the screw.
When properly installed and adjusted, attach the product label, which includes the CE mark on the
right side of the lower part of the operator cover (see illustration).
Apply the EM logotype to the cover – see illustration.
Only for SE: Apply the SITAC label next to the product label - see illustration.
4
0
25
SITAC XXXX
TG XXXX/XX
Ersätter lås med fallkolv till
typgodkända
slagdörrar enl. förteckning
Skydd mot olyckor vid
rörliga anordningar
Entr
ematic
Group
AB
LODJURSGAT
AN 10
LANDSKR
ONA SWEDEN
FACTORY NO. X
DESIGNATION
ART. NO.
YEAR+WEEK
10
0419
7
XXXXXXX
XXXXXXXXXXXXX
TYPE
XXXXXXXXXX
TEMPERATURE
XXXXXXXXXXX
XXXX
LOAD
XXXXX
PROD. ORDER
XXXXXXX
XXXXXX
XX/XX
Hz
PROJECT/SERIAL NO.
XXX
XXXXXXX
W
XXXX
A
VAC
xxxxxxxxxxxxx
xxxxxxxxxxxxx
SÜD
CLASSIFICATION DIN 18650
1 2 3 4 5 6 7 8
SITAC
1002
xxxxxxx
xxxxxxx
1002
Disconnect from
supply before
servicing
59
Issue 2014-11-24
1005088-EMEI-11.0
12 Cover