21
•
Number of rings before AA picks up, default = 2
•
Custom greeting message cleared
•
ID assigned to a phone line when AA is disabled,
default = ID 10
iii) Operator ID, default = ID 10
iv) Registered handset ID table cleared
b. Call Forwarding table:
i) Call Forwarding On/Off for all registered handsets,
default = Off
ii)
Clear Call Forwarding numbers for all registered
handsets
c. Transfer calls for SP-922 Auto-Attendant Operator to
wired PBX operator, if SP-922 is adjunct to the wired PBX,
default = transfer to PBX operator off.
Notes
:
1. Reset button is indented to prevent accidental system
reset.
2. Because the base’s security code is reset and the handset
registration table is cleared, all handsets (including
administrator) and additional base(s) need to be re-
registered after a base station reset.
Additional Base Station Features
1. 4-channel Auto-Attendant
a. 4 Auto-Attendant can be active at the same time in case of
4 simultaneous incoming calls.
b. Allows private paging to a single handset (with individual
Handset ID) or group paging to a group of handsets (with
Group ID).
c. Per line AA enable/disable by administrator.
d. When disabled for a line, the administrator can set all
handsets to ring with an incoming call on that line, or a
particular Handset/Group ID (either one; not
simultaneously) can be assigned to have both incoming
and outgoing call privileges on that line. See AA
Configuration by Administrator.
e. Up to 128 seconds customizable main greeting message.
22
2. Supports both DTMF and Pulse dialing
a. From an administrator handset (Handset 10 or 11), press
MENU-9-2-3 to select Tone or Pulse dialing mode.
b. Default is Tone dialing.
Administrator Features
System Configuration
a. Removes Handset ID from the base station.
b. Set next Handset ID to be assigned.
i) Dial mode (tone/ pulse), default = tone.
ii) Flash time (100ms- 900ms), default = 600ms.
