EnGenius EP902, User Manual

Page: 60 / 66

h. Press 8 to Change Password:
(1) Enter original (4 digits) of handset then press OK (Left) soft key
when enter this menu.
(2) Enter new password (4 digits) then press SAVE (Left) soft key to
confirm new password.
i. Press 9 to set Headset Ring: See Headset Ring operation on Page
52.
7. Press
6 to set Base Settings:
When enter this menu, you must enter Base PIN code first (4 digits).
Re: The PIN code is for Base Settings. Default is “0000”.
a. Press
1 to set DTMF Duration.
(1)
Enter the DTMF duration (90~200ms), press OK (Left) soft key to
confirm the setting. Default is 100ms.
Re: Please check with your dealer before you change it. If the duration
not matches with PSTN or PBX setting, it may operate faultily.
b. Press 2 select flash key timing. Default is 600ms.
(1) Use or to scroll through option 1~9 (100~900ms). Or
press digit key (1~9) directly.
(2)
Press SELECT (Left) soft key to confirm selection.
Re: The default value (600 ms) works in most areas. Changing this
setting may cause Flash key not working. Change only when you
are certain of the new value would work.
c. Press 3 to set Assign Next HS
(1)
Enter 2-digit handset ID followed by pressing OK (Left) soft key.
(2)
When register a new handset, the base will assign the specific
handset ID which assigned in advance to the new handset.
d. Press 4 to set Clear HS
(1)
Enter 2-digit handset ID followed by pressing OK (Left) soft key.
(2)
The base will erase the handset ID from system.
e. Press
5 to Change PIN:
(1)
Enter the new Base PIN followed by OK (Left) soft key.
Re: Default Base PIN is “0000”.
f.
Press 6 to set Auto Hang Up:
(1)
Use CHANGE (Left) soft key to select and confirm on or off. The
Re: When setting “on”, the EP902 will automatically hang up if the far
end caller hung up already. However, this function depends on if
there is “dial tone or busy tone” signal sent out by PBX or PSTN,
after the call hung up.
g. Press 7 to Set Time to support DTMF Caller ID:
~60~