enervent eWind LTR-2, Installation Instruction

Page: 6 / 96

6
READ ME FIRST
This document is intended for everyone involved
in installation of Enervent ventilation units. The
equipment described in this manual must be installed
by skilled persons only, according to the instructions
given in this manual and local law and regulations.
Failure to comply with instructions in this manual voids
the warranty of the equipment, and possibly results in
harm to people or property.
The equipment described in this manual must not be
used by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been
given supervision or instruction concerning use of the
equipment by a person responsible for their safety.
Tables at the end of this manual list:
• Ventilation units introduced in this document
• Components included in the delivery.
NOTE:
If your delivery does not include all
the components listed in the Models and
components table at the end of this manual,
check your order and contact your seller or
Enervent before starting installation.
Type plate
The type plate is located near the main power switch or
inside the ventilation unit. Before you start reading,
check the type of the unit from the plate.
Type designation
The type designation contains three parts:
1. The first part of the type designation indicates the
chassis of the ventilation unit, for instance LTR-3, or
Pandion.
2. The next letters indicate the type of automation
that the ventilation unit is equipped with, in this
case eWind.
3. The next letter of the type designation indicates
the type of supply air heater that the ventilation
unit is equipped with, E= electrical, W= water.
4. The next letters if any, indicate the type of pre-
heater/pre-cooler or supply air cooler, CHG=
Cooling Heating Geo, CG=Cooling Geo.
Example: Pandion eWind-E-CHG.
ilmanvaihtolaite
ventilation unit
TYYPPI/TYPE:
W/ V/ HZ / A:
www.enervent.com
SRJ. NRO/SERIAL NO:
IP 20