enervent eWind LTR-2, Installation Instruction

Page: 20 / 96

20
Installing models Pinion, Pingvin,
Pingvin XL, Pandion, Pelican,
Pegasos and Pegasos XL
Wall installation
Pinion, Pingvin, Pingvin XL and Pandion
To prepare:
1. Prepare the holes in the wall.
2. Bring in the ducts through the cross cut in the
vapor barrier to the height to which the unit will
be mounted.
3. Seal the gap between the duct and the vapor
barrier using for example duct tape.
4. Install an insulating plate at the back of the
ventilation unit or otherwise prevent the structure
borne noise.
•
Soft foamed plastic sheets are recommended
(not included in the delivery).
5. Install an extra layer of insulation outside the
ventilation unit (for example foamed plastic), if the
unit is installed with its side against exterior wall
or if there is any other reason to suspect that the
outside of the unit will condensate.
•
Condensation risk is present in areas where the
climate is cold.
• Installation varies for different models.
To install:
1. Install the rear attachment bracket at the desired
height.
2. Lift the unit on the bracket.
NOTE:
Remove the heat exchanger before you
lift the unit. This will make the unit much lighter
to handle. Remove or secure the doors so that
they do not open during lifting.
3. Attach the unit to the wall by the upper mounting
lugs.
•
Make sure to install the rubber bushings for
the fastening screws. (Pingvin and Pandion
only).
4. Attach the rear attachment bracket to the unit’s
base using sheet metal screws.
NOTE:
It is essential for the proper disposal of
condensate water that a Pingvin unit is installed
slightly tilted backwards. This must be verified
using a spirit level.
• Make sure that the ventilation ducts are
insulated according to the instructions in
chapter
"
Insulating ventilation ducts" on page
11.
5. Make the applicable electrical and plumbing
connections according to the electrical and
principal diagram at the end of this manual.
Ceiling installation
Pinion, Pingvin, Pingvin XL and Pandion
The dimensional drawings for each of the models can
be found at the end of this manual.
To install:
1. Install the installation plate on the ceiling.
2. Install the supplied duct couplings and insulation
rings (Pingvin, Pingvin XL and Pandion), or
insulation sheet (Pinion) on top of the unit.
3. Unscrew the cover of the electrical cabinet.
• Prepare the lead-ins on unit for the cables
coming through the ceiling.
• Leave the electrical cabinet cover open.
4. Guide the unit power cable to run in front of the
hook to keep the cables from squashing between
the unit and the ceiling installation plate.
NOTE:
Remove the heat exchanger before you
lift the unit. This will make the unit much lighter
to handle. Remove or secure the doors so that
they do not open during lifting.
• Make sure that there is enough space
underneath the ceiling plate to fit the unit.
5. Lift the unit up.
6. Hook the unit to the front side of the ceiling
installation plate.