EnerSys OutBack POWER Mojave OGHI8048A, Operator'S Manual

Page: 90 / 116

90
900-00275-01-001 Rev A ©2021 OutBack Power. All Rights Reserved.
Service
5. Carefully remove the control board, pulling toward the front of the inverter, as shown in Figure 41 .
Figure 41 Dismounting Control Board
6. Replace the control board. Perform all previous steps in reverse order.

Insert the control board.

Replace the screws
H
. Do not tighten.

Replace the connectors
G
and
F
. See Figure 40 if necessary.

Replace the ribbon cable
E
and the RP-SMA cable
D
. See Figure 40 if necessary.

Replace the securing screw
C
. See Figure 39 if necessary.

Tighten all screws
H
.

Replace the A
UX
terminal block
A
. See Figure 39 if necessary.
Replacement is complete.
H
H
H
H