EnerSys OutBack POWER Mojave OGHI8048A, Operator'S Manual

Page: 86 / 116

86
900-00275-01-001 Rev A ©2021 OutBack Power. All Rights Reserved.
Service
Preparatory Steps
Follow the procedures which are applicable to the system. If any elements are not present, ignore
those procedures.
Tools Needed
Digital multimeter (DMM)
5 mm hex (Allen) wrench
#1 Phillips screwdriver
#2 Phillips screwdriver
Torque driver
Disconnection
Power down and disconnect all power sources from the inverter prior to performing any service.
Turn off all circuit breakers connected to the inverter.
L
OAD
circuit breaker
G
RID
circuit breaker
G
EN
circuit breaker
DC circuit breakers
Generator start circuit
Voltage Check
Once these connections are turned off, verify with a voltmeter that NO voltage is present at the DC+
to DC– terminals. Refer to Figure 37 on page 80.
WARNING: Shock Hazard and Equipment Damage
It may take time for internal capacitance to fully discharge. Ensure full discharge for at least
one minute (less than 1 Vdc) prior to continuing. The inverter’s capacitors may retain a
sizable charge, which can cause electrical shock or severe equipment damage during
normal handling. This damage is not covered under the unit’s warranty.