ENERGREEN RoboMAX, Use And Maintenance Instruction Manual, Page: 78 / 105

70
© 2017 Energreen Srl
Professional machinery
9 - MAINTENANCE
• Maintenance must only be carried out by ENERGREEN Customer Care Services or
qualified personnel.
• Always wear personal protective equipment before performing any work on the
machine.
WARNING:
9.1 - INTRODUCTION
To obtain the machine's best performances and ensure maximum durability of all its components, the
instructions for use and maintenance must be followed carefully by machine operators.
Therefore, we recommend our customers to carefully read these instructions and consult the manual
any time they need advice on how to eliminate possible inconveniences. Because the machine
usually operates in contact with water, sand, earth, etc., regular lubrication is necessary. This is of vital
importance not only to ensure the long life of the machine, but also to keep running costs low.
For further information, please contact our service centre:
Contact ENERGREEN customer care: Tel.: +39 0444 1511 200
email: service@energreen.it
9.2 - GENERAL REQUIREMENTS
• - Before carrying out any maintenance or inspecting and / or checking the machine, turn off the
diesel engine and remove the ignition key.
• - When removing or reinstalling machine parts, always use suitable extractors, spanners and
equipment that will not damage the specified components.
• - To release parts that are solidly adherent, use copper or wooden hammers.
• - Separate the pieces of the various units and partially screw the nuts onto their corresponding pins
or stud bolts. Clean the parts using brushes or rags, then wash them using paraffin or warm water
and remove all residues using compressed air.
• After grinding or finishing using abrasive tools, thoroughly clean the parts, making sure that all the
abrasive dust has been removed.
• - When re-assembling the pieces, make sure that they are clean. and then lubricate appropriately.
• - Pay great attention to the safety rings and cotter pins. Replace them immediately if there are
signs of breakage.
• Maintenance of the machine and/or equipment must be carried out by authorised personnel.
9.3 - EXTRAORDINARY MAINTENANCE
These are repairs or replacements of one or more components of the machine, which only usually
become necessary after years of good operation and which do not alter the characteristics of the
machine. In the case of substantial modifications, the manufacturer cannot be considered liable for any
risks that could arise.
These interventions must be performed by authorised personnel.