Batch Controller RA33
Appendix
Hauser
75
Outputs
Settings only needed if outputs (e.g. relay or analog out-
puts) should be used.
Universal output
Settings for the universal output (current or pulse output).
Failure current
310009-00 Set the current to be output in the event of an error (e.g.
cable open circuit at the input).
Numerical value, max. 8 digits including decimal separa-
tor.
Meas.val. corrct.
Here, you can correct the output current value (necessary
only if the device that carries out the further processing
cannot compensate for any measurement section toler-
ances).
Proceed as follows:
1.
On the connected device, read out the displayed
value in both the upper and lower measuring range.
2.
Enter the upper and lower target value and actual
value.
Start Value
Lower correction value.
Target value
310051-00 Enter the lower setpoint here.
Actual value
310052-00 Here, enter the lower actual value which is displayed at
the connected device.
Full scale value
Upper correction value
Target value
310054-00 Enter the upper setpoint here.
Actual value
310055-00 Here, enter the upper actual value which is displayed at
the connected device.
Diagnostics
Device information and service functions for swift device
check.
ENP device name
000020-00 Please send these details with any questions about the
device.
Device name
000021-00 Please send these details with any questions about the
device.
Serial Number
000027-00 Please send these details with any questions about the
device.
Order Code
000029-00 Please send these details with any questions about the
device.
Order Identifier
000030-00 Please send these details with any questions about the
device.
