Batch Controller RA33
Commissioning
Hauser
25
6
Commissioning
Make sure that all post-connection checks have been carried out before you commission your
device:
• See Section ’Post-installation check’,
• Checklist Section ’Post-connection check’,
After the operating voltage is applied, the display and the green LED are illuminated. The device is
now ready to operate and can be configured via the keys or the "FieldCare Device Setup" parameter
configuration software (
23).
!
Note!
Remove the protective foil from the display, as otherwise legibility is impaired.
6.1
Quick commissioning/make it run
For quick commissioning of the "standard" batch controller application, you only have to enter a few
operating parameters in the menu
Setup
.
Prerequisites for quick commissioning:
• RTD temperature sensor, 4-wire direct connection
Menu/setup
É
Units
: Select unit type (SI/US)
É
Signal type
: Select the signal type for flow (pulse or current)
É
Unit
: Select the flow unit
É
Counter unit
: Specify the unit for the volume counter
É
Pulse value, value
: Enter the unit and value for the pulse value of the flow transmitter (for
"pulse" signal type)
É
Meas. range start
and
Meas. range end
(for "current" signal type)
É
Date/time
: Set the date and time
The device is now operational and ready to control batching.
You can configure device functions, such as data logging, tariff function, bus connection and the
scaling of current inputs for flow or temperature, in the "Advanced setup" menu.
6.2
Applications
The following is an explanation of the application possibilities, including brief operating instructions
for the respective device settings.
• Batch controller with flow measurement and 1-stage batching,
• Batch controller with flow measurement and 2-stage batching,
• Batch controller with API temperature compensation,
• Batch controller with API temperature/density compensation,
