Installation
Micropilot S FMR540 4 to 20 mA HART
18
Hauser
Standard installation FMR540 with
parabolic antenna
• Observe installation instructions,
• Marker is aligned towards tank wall.
The marker is located clearly visible on the
sensor neck or the flange.
• After mounting, the housing can be turned
350° in order to simplify access to the display
and the terminal compartment.
• Ideally the parabolic antenna should protrude
from the nozzle (1). Particularly when using
the alignment device, please ensure that the
parabolic reflector is protruding from the
nozzle/roof so as not to inhibit alignment.
Note!
For application with higher nozzle install
parabolic antenna completely in the
nozzle (2), including RF-wave guide (3).
• The parabolic antenna should be installed
vertically.
To avoid interference reflections or for
optimum alignment within the vessel, the
FMR540 with optional alignment device can
be swiveled by 15° in all directions.
For more informations please see Operating
Instructiosn KA00274F/00/A2.
Please, contact Hauser Service
organization for commissioning.
L00-FMR54xxx-17-00-00-en-017
1
2
D
H
clearance
vertical to the
liquid surface
clearance
Antenna size
200 mm (8")
250 mm (10")
D [mm (in)]
173 (6.8)
236 (9.4)
H [mm (in)]
(without antenna extension)
< 200 (< 7.9)
< 200 (< 7.9)
