Trouble-shooting
Micropilot S FMR540 4 to 20 mA HART
68
Hauser
9.5
Return
The following procedures must be carried out before a transmitter is sent to Hauser e.g.
for repair or calibration:
• Remove all residue which may be present. Pay special attention to the gasket grooves and crevices
where fluid may be present. This is especially important if the fluid is dangerous to health, e.g.
corrosive, poisonous, carcinogenic, radioactive, etc.
• Always enclose a duly completed "Declaration of contamination" form (a copy of the "Declaration
of contamination" is included at the end of this operating manual).
Only then can EHauser transport, examine and repair a returned device.
• Enclose special handling instructions if necessary, for example a safety data sheet as per
EN 91/155/EEC.
Additionally specify:
• An exact description of the application.
• The chemical and physical characteristics of the product.
• A short description of the error that occurred (specify error code if possible)
• Operating time of the device.
9.6
Disposal
In case of disposal please seperate the different components according to their material consistence.
9.7
Software history
9.8
Contact addresses of Hauser
The addresses of Hauser are given on the back cover of this operating manual.
If you have any questions, please do not hesitate to contact your Hauser representative.
Date
Software version
Software changes
Documentation changes
10.2006
V 01.01.00
Original software.
Operated via:
– ToF Tool from version 4.6
– HART communicator DXR375
with Rev. 1, DD 1.
07.2009
V 01.01.02
Adaptation parabolic antenna
