Endress+Hauser Liquisys M CCM223, Operating Instructions Manual

Page: 36 / 124

Commissioning Liquisys M CCM223/253
36 Hauser
6.3 Quick start-up
After power-up, you must make some settings to configure the most important functions of
the transmitter which are required for correct measurement. The following section gives an
example of this.
User input Setting range
(Factory settings,
bold)
Display
1. Press the
F
key.
2. Enter the code 22 to edit the setup. Press
F
.
3. Press
S
until you get to the "Service" function
group.
4. Press
F
to be able to make your settings.
5. In S1, select your language, e.g. "ENG" for English.
Press
F
to confirm.
ENG = English
GER = German
FRA = French
ITA = Italian
NEL = Dutch
ESP = Spanish
6. Press PLUS and MINUS simultaneously to exit the
"Service" function group.
7. Press
S
until you get to the "Setup 1" function
group.
8. Press
F
to be able to make your settings for
"Setup 1".
9. In A1, select the desired type of sensor.
Press
F
to confirm.
120 = CCS120
140 = CCS140
141 = CCS141
240 = CCS240
241 = CCS241
963
10. Select the desired display unit in A2, press
F
to
confirm.
mg/l
ppm
ppb
11. If the proximity switch INS is connected, you can
switch on flow monitoring of the sample stream
assembly CCA250 in A3. Press
F
to confirm.
Off
INS
12. In A4, enter a delay time to suppress controller
switch-off in case of short-term flow-rate
undershoots. Press
F
to confirm your input.
0 s
0 to 2000 s
13. In A5, enter the delay for controller switch-on.
With chlorine / chlorine dioxide control, a delay
until the reception of a representative measured
value is recommended after a long flow rate
failure.
0 s
0 to 2000 s
S
SERVICE
S1
Language
ENG
A
SETUP 1
A1
Sensor
140
A2
Unit
mg/l
A3
Cont.stop
Off
A4
s
Off Delay
0
A5
s
On Delay
0