Endress+Hauser Fieldgate FXA320, Operating Instructions Manual

Page: 80 / 106

Fieldgate FXA320 7 Viewing Information (User Mode)
Hauser 78
Error Log The Error Log records Fieldgate error messages, e.g. failed password change etc. Up to 25 lines are
displayed. The log is deleted when the Fieldgate is switched off. Table 7-6 explains the significance
of the messages.
Error log message Meaning
cannot deliver email to < 1st / 2nd > recipient <service
alarm / limit alarm / measurement>: SMTP open error
<errorcode>
cannot deliver email to < 1st / 2nd > recipient <service
alarm / limit alarm / measurement>: SMTP send error
<errorcode>
cannot deliver email to < 1st / 2nd > recipient < service
alarm / limit alarm / measurement >: SMTP close error
<errorcode> Alarm e-mail could not be sent. Error codes:
• 1: Invalid SMTP parameter.
• 2: SMTP Server domain could not be resolved.
• 3: Network error - target server unreachable.
• 211: System status, or system help reply.
• 214: Help message.
• 220: <domain> Service ready.
• 221: <domain> Service closing transmission channel.
• 250: Requested mail action okay, completed.
• 251: User not local; will forward to <forward-path> .
• 354: Start mail input; end with <CRLF>.<CRLF>.
• 421: <domain> Service not available, closing
transmission channel.
• 450: Requested mail action not taken: mailbox
unavailable [E.g., mailbox busy].
• 451: Requested action aborted: local error in processing.
• 452: Requested action not taken: insufficient system
storage.
• 500: Syntax error, command unrecognized.
• 501: Syntax error in parameters or arguments.
• 502: Command not implemented.
• 503: Bad sequence of commands.
• 504: Command parameter not implemented.
• 550: Requested action not taken: mailbox unavailable
[E.g., mailbox not found, no access].
• 551: User not local; please try <forward-path>.
• 552: Requested mail action aborted: exceeded storage
allocation.
• 553: Requested action not taken: mailbox name not
allowed [E.g., mailbox syntax incorrect].
• 554: Transaction failed.
email ok for < 1st / 2nd > recipient <service alarm / limit
alarm / measurement This message appears only if one of the two messages above
has appeared, but the e-mail was successfully sent. The mes-
sage cancels its predecessor.
DHCP: cannot get IP address DHCP Server not answering. In this case the manual
address under Settings -> Network -> IP-Address is used.
cannot set IP address Ethernet: IP address could not be set.
Possible cause: invalid IP address structure (only the format
a.b.c.d (e.g. 192.168.22.33) is allowed).
cannot set netmask ditto for the netmask (cannot be set by user!).
cannot add route to gateway The gateway could not be accepted. Check the IP domain
settings, if necessary, restart Fieldgate.
DNS initialization failed Ethernet: initialization of the DNS has failed.
This indicates incorrect DNS specifications.
Modem DNS initialization failed DNS: initialisation of the DNS has failed.
This indicates incorrect DNS specifications.
no response from DNS server, used DNS Cache to resolve IP
address ( <Domain> / <IP> ) The DNS Server is not answering. The Fieldgate could
however resolve the domain via the integrated DNS cache.
The message appears when the DNS server has failed.
Check the DNS server.
cannot resolve Domain via DNS: <Domain> The listed domain could not be resolved. Either this domain
does not exist or the DNS server has failed.