Endress+Hauser Fieldgate FXA320, Operating Instructions Manual

Page: 47 / 106

5 Commissioning Fieldgate FXA320
45 Hauser
6 When configuration is complete, select Settings => Special to restart the system and register
the changes
– In the System Restart dialog, check the "Confirm System Restart" box and press Send
– The Fieldgate restarts with the changes made via the service interface permanently stored
7 When the restart is complete, close the Web browser, unplug the service connector and switch
off the Fieldgate
8 Insert the SIM card in the receptacle provided and close the front panel.
9 Ensure that the antenna is connected and switch on the Fieldgate. Connect the Fieldgate via
the host computer as described in chap. 5.4.4 or chap. 5.4.5.
5.4.3 Set up the dial-up connection in your computer
A dial-up connection can only be set up if the PC has a modem and the GSM provider supports CSD.
Before you set up the dial-up connection, make sure that the GSM parameters have been configured
as described in Chapter 5.4.2.
1 Start the New Connection Wizard and follow the procedure in chap. 5.1.4
– In the Select a Device dialog, select the analog or GSM modem
– In the Connection Name dialog, enter e.g. Fieldgate GSM Connection
– In the Number to Connect dialog, enter the phone number of the Fieldgate
– All other settings are identical
2 In the Network Connections dialog ( Start > Settings > Network Connections ), right-
click on the new connection, e.g. Fieldgate Analog Connection and select Properties.
The Properties dialog opens :
3 Select the modem used with the connection, then the Networking tab
– Now select Internet Protocol (TCP/IP) and press Properties
4 In the Properties dialog that now appears press the Advanced... button, the dialog
Advanced Properties opens at the General tab
– Deactivate the " Use default gateway on remote network " option, press OK
– Close all dialogs with OK .