Emerson XM678D, Operation And Installation Manual

Page: 66 / 76

58 • XM678D I&O Manual 026-1219 Rev 3
OdC F-C
Compressor and fan
status with door
open
no; FAn; CPr; F-C
no = normal; Fan = Fan OFF;
CPr = Compressor OFF;
F_C = both Compressor and Fan OFF
rrd 15
Output restart delay
with door open
0 to 255min
The outputs stopped by the OdC
parameter can restart after the rrd time.
ENERGY SAVING
ESP P1
Energy saving
probe selection
nP; P1; P2; P3; P4; P6;
tEr
-
HES 0
Temperature
increasing during
Energy Saving
[-54°F to 54°F]
[-30.0°C to 30.0°C]
Sets the increasing value of the setpoint
during the Energy Saving cycle.
PEL nU
Energy saving
activation when
Light or/and AUX
are switched OFF
nU(0); LIG(1); AUS(2);
LEA(3)
Energy saving enabled when:
LiG : light switched OFF

AUS : AUX switched OFF

LEA : both light and AUX switched
OFF
nU : function not used
LAN MANAGEMENT
LMd Y
Defrost
Synchronization
n; Y
n = the section does not send a global
defrost command.

Y = the section sends a command to
start defrost to other controllers.
dEM Y
Defrost end
Synchronization
n; Y
n = the end of the LAN defrosts are
independent.

Y = the end of the LAN defrosts are
synchronized.
LSP n
LAN setpoint
Synchronization
n; Y
n = the setpoint value is modified only
in the local section.

Y = the section setpoint, when
modified, is updated to the same value
on all the other sections.
LdS n
LAN Display
Synchronization
(temperature sent
via LAN)
n; Y
n = the setpoint value is modified only
in the local section.

Y = the value displayed by the section is
sent to all the other sections.
LOF n
LAN ON/OFF
Synchronization
n; Y
This parameter indicates if the ON/OFF
command of the section will act also on
all the other sections:
n = the ON/OF command acts only in
the local section.

Y = the ON/OFF command is sent to all
the other sections.
LLi Y
LAN Light
Synchronization
n; Y
This parameter indicates if the light
command of the section will act also on
all the other sections:
n = the light command acts only in the
local section.

Y = the light command is sent to all the
other sections.
Label Value Description Range Notes
Table 24-1 - Default Parameter Map