PCM-22 Rotary Knife Controller
52
© EMERSON Motion Control
Input Functions
On the Input Functions screen, the left-hand column (Input
Assignments) of numbers corresponds directly to the input lines on the
drive. The next column (Function) lists all of the input functions
available and shows which input line each function is assigned to on the
drive. Any functions assigned to Line Zero are inactive. In cases where
two or more functions are assigned to the same input line, those
functions will appear on the same line in the left column.
Most of the input functions are discussed in the 230V FX Drives Setup
and Programming Operator's Manual (P/N 400282-00), 460V FX Drives
Setup and Programming Operator's Manual (P/N 400310-00) or 525
Programmable Motion Controller Installation and Operation Manual
(P/N 400276-01) as appropriate. The input functions which are specific to
the PCM-22 are discussed in this section.
Figure 28
Input Functions Screen
To assign an input function, use the up/down arrows to move the cursor
to the desired input function, type in the desired line number and then
press Enter. The left hand window will then show the function beside
the selected input line. If you wish to access a function that is off the
screen, press the up/down arrow key or page down until the cursor is on
the desired function. The screen will scroll as needed.
When an input line is activated, the corresponding input line on the PCX
screen will be highlighted. This may be useful when setting up or testing
the drive inputs.
Inputs require an external voltage source for operation. This voltage
source must be in the range of 10.5 to 30 VDC.
