GB
65
Step 4. Dishwasher installation steps
1. Fit the condensation strip under the work surface of the
cabinet. Please ensure the condensation strip is flush
with the edge of the work surface.
2. Connect the inlet hose to the cold water supply.
3. Connect the drain hose.
4. Connect the power cord.
5. Place the dishwasher in position.
6. Level the dishwasher. The rear foot can be adjusted
from the front of the dishwasher by adjusting the screw
in the middle of the base of the dishwasher using a
cross-head screwdriver. To adjust the front feet, use a
flat-head screwdriver and turn the front feet until the
dishwasher is level.
7. Adjust the tension of the door springs using a hex
key, turning in a clockwise direction to tighten the left
and right door springs. Failure to do this could cause
damage to your dishwasher.
8. The dishwasher must be secured in place. There are
two ways to do this:
A.
Normal work surface: Secure the dishwasher to the
work surface with the wood screws and retaining
strip.
B.
Marble or granite work top: Fix the sides with
screws.
A
B
Step 5. Levelling the dishwasher
The dishwasher must be level to ensure correct dish rack
operation and wash performance.
9. Place a spirit level on the door and the rack guide
inside the dishwasher as shown to check that the
appliance is level.
10. Level the dishwasher by adjusting the three levelling
feet individually.
11. Once the dishwasher is level, make sure that it cannot
tip over.
Check level
front to back
Check level
side to side
NOTE
:
The maximum adjustment height of the feet is 50 mm.
