25
Parameter setting
Actuator KNX S1R-B4 compact
• Version: 12.09.2022 • from application 1.0 • Technical changes and errors excepted.
5.2.1.2.Manual
The actuator has two movement position memories for manual movement. These
positions can be
•
be called up via object 15 "Move to manual position memory", for example with
a push-button.
•
be retrieved by a specific telegram sequence. The command sequence of these
telegrams can be sent, for example, with the down button of an appropriately
configured bus push button (long button press followed immediately by a short
button press). In this way, only one position can be recalled.
Object 15 can be used to move to one or two (object value 0 and 1) positions.
For shutters, both the movement and the slat position can be stored.
If retrieval via the command sequence is activated, the position is retrieved as soon as
a "1" is received via the long-term object and within 2 seconds a "1" is also received via
the short-term object. If "Use different positions for object values 0 and 1" is selected,
the position for object value 0 is retrieved.
The stored positions can be changed via the learning object. The learning object
ensures that the current position is stored in the memory. All parameters (height and
slat in the case of blinds) or only changed parameters can be adopted (see
„Application when programming“
5.2.1.3.Automation - external
The ‘External automation’ menu item appears if the external automation is selected in
‘Control’. In this case, the position memory can be activated for the automatic
movement. The position set here can be overwritten via a learning object at any time.
The memorised position can be retrieved again at a later time. For configuration
options, see Chapter ‘Manual’ on Page 31.
Use position memory
no • yes
Use different positions for object values 0
and 1
no • yes
(if ‘yes’ is selected, there will be a division
into positions for object value 0 and object
value 1)
Position in %
0...100
Allow calling via command sequence: long-
term = 1, short-term = 1
no • yes
Use learning object for new position
no • yes
Transfer when programming
(when learning object is used)
• all parameters
• changed parameters only
