|
Operating modes and functions
77
|
ELSA LANCOM Wireless IL-II
|
EN
ings for all types of connections. With this information on hand, you can now
begin feeding your least-cost router...
4.5.2
Setting up the least-cost router
Two essential questions must be clarified with regard to configuring the
least-cost router:
Which operating modes of the
ELSA LANCOM Wireless IL-11
should the
services of the least-cost router use?
Which calls should be routed over which provider?
To answer these questions, proceed as follows:
햲
In
ELSA LANconfig
, go to the 'Least-cost router' configuration section on
the 'General' tab.
햳
Enable the least-cost router function. The least-cost router can only be
enabled if you have already set the unit time manually or the time has
already been received from the ISDN network itself (see also 'Time for
the Selection' further below). Activate the following operating modes for
the least-cost router as required:
Router
LANCAPI
If you have also activated least-cost routing for the router module, connec-
tions may be established via providers that do not transmit connect-charge
information. The connect-charge monitoring may thus be inadvertently lost.
In this case, use the time budget as an alternative.
햴
Change over to the 'Time periods and public holidays' tab. Open the
Least-cost table
, create a new entry and enter the following data:
Which prefix should be rerouted?
Which provider should be used for this prefix? If you have entered
several network prefixes separated by semicolons, the LCR will auto-
matically try the next prefix if the current one is busy.
On which days and what times should the routing be active? Please
note that time blocks cannot extend from one date to another (i.e.
6:00 p.m. to 6:00 a.m.).
Should the call be handled by the default telephone provider if all
call-by-call providers are busy? If 'Automatic Fallback' is disabled,
100324 Wireless IL-11.book Seite 77 Montag, 30. Oktober 2000 4:13 16
