Operating modes and functions
|
|
ELSA LANCOM Wireless IL-II
|
66
EN
Layer name
The protocol settings will be saved under this name. In the name list,
select the settings with the layer name for the appropriate connection.
Encapsulation
Specify here whether an Ethernet header should be added to the data
packets. Normally the setting 'Transparent' will be sufficient; this setting
may only be required for HDLC connections to third-party devices.
Layer-3
Layer-3 protocol for the connection. Recognized automatically in the
case of some incoming connections.
An additional entry is required in the PPP list when using PPP.
An additional entry is required in the scripts list when using scripts.
Layer-2
Layer-2 protocol for the connection.
Options
Enables data compression and channel bundling. These options are only
effective when supported by the protocols of Layer 2 and Layer 3.
Layer-1
Layer-1 protocol for the connection. Recognized automatically in the
case of some incoming connections.
4.3.5
Call charge management
The capability of the router to automatically establish connections to all
required remote stations and close them again when no longer required pro-
vides users with extremely convenient access to the Internet, for example.
However, quite substantial costs may be incurred by data transfer over paid
lines if the router is not configured properly (e.g. in the filter configuration) or
by excessive use of the communications opportunities (e.g. extended surfing
in the Internet).
Settings in the charge module
The interface settings for the
ELSA LANconfig
can be found in the 'Manage-
ment' configuration section on the 'Charges' tab, or under
/Setup/Charge-module
during Telnet or terminal sessions.
100324 Wireless IL-11.book Seite 66 Montag, 30. Oktober 2000 4:13 16
