ELSA LANCOM Business 6000, Manual

Page: 90 / 174

Operating modes and functions
|
|
ELSA LANCOM Business 6000
|
90
EN
Use the router interface settings to determine the parameters to be used for
each interface (i.e. each S
0
port) for the LANCAPI . These parameters do not
apply to the other operating modes of the units. Specifically, they are:
Subscriber numbers (MSN/terminal device selection numbers)
The LANCAPI responds to incoming calls for these numbers. Multiple
numbers are separated by semicolons. If no number is specified, the
router will respond to all incoming calls.
Access to LANCAPI
Here you can completely disable the LANCAPI functions for the interface,
or enable it only for incoming or outgoing calls.
Transfer of own subscriber number
Normally the number specified in the CAPI application is transferred to
the remote station via the
LANCAPI during active call establishment. No
number is transferred by the LANCAPI if this number has not been
specified or the number is invalid. This option lets you transfer the first
number entered in the 'Subscriber number' field if no number has been
specified in the CAPI application.
6.8.5 Layer list
The list of communications layers in the ELSA LANconfig can be found in the
'Communication' configuration section on the 'General' tab, or under
/Setup/WAN-module/Layer-list
during Telnet or terminal
sessions.
A layer defines a specific combination of protocol settings to be used for data
transfer to other devices. Specifically, they are:
Layer name
The protocol settings will be saved under this name. In the name list,
select the settings with the layer name for the appropriate connection.
Encapsulation
Specify here whether an Ethernet header should be added to the data
packets. Normally the setting 'Transparent' will be sufficient; this setting
may only be required for HDLC connections to third-party devices.