ELSA LANCOM Business 6000, Manual

Page: 33 / 174

|
Configuration and management
33
|
ELSA LANCOM Business 6000
|
EN
This is the case using the factory default settings because the default
protocol (default layer) is set to PPP.
You may, however, want to change the default layer for LAN-to-LAN
connections, for example, to a different protocol after the first configuration
run. Then the device will no longer take calls on the dial-up connection using
the PPP settings. The solution to this is to agree upon a special calling number
for configuration access. If the device receives a call on this number, it will
always use PPP, regardless of any other settings made on the router. Only a
specific user name which is automatically entered by the
ELSA LANconfig
program during call establishment will be accepted during the PPP
negotiations.
햲
Switch to the 'Security' tab in the 'Management' configuration section.
햳
In the 'Configuration access' field, choose whether the configuration is
fully accessible, read-only or not accessible from remote networks.
Alternatively, enter the following command during a Telnet or terminal
connection:
set /setup/config-module/WAN-config [on][read][off]
If you wish to block access to the router from the WAN entirely, set
configuration access from remote networks to 'denied'.
햴
In the 'Configuration access' field, enter a calling number of your
connection which is not used for other purposes as the calling number.
Alternatively, enter the following command:
set /setup/config-module/Farconfig 123456
햵
You can protect the configuration of the device by assigning a password.