24
⁄0
⁄4
⁄1
⁄2
⁄3
!5
!5
!8
!6
!7
i
⁄0
Raise the looper threader lever until it clicks into
place.
!5
Looper threader lever
⁄1
Lower the looper threader lever until it knocks into
place.
⁄2
Make sure that the thread comes out from the hole of
the upper looper tip.
!6
Thread end
!7
Hole of lower looper tip
⁄3
Draw 4˝ (10 cm) of the thread under the toe of the foot,
and pull it to the rear between the foot and the upper
knife.
!8
Upper knife
⁄4
Return the lower threader switch lever to the “SEWING”
position.
i
Lower threader switch lever
Close the looper cover and lower the presser foot
lifter.
NOTE:
If the thread does not come out from the hole, follow
the procedure from step
⁄0
again.
Podignite polugu uvlakača donjeg konca sve dok ne
klikne na svoju poziciju.
Poluga uvlakača donjeg konca
Spustite polugu uvlakača sve dok ne ulegne na
svoju poziciju.
Uverite se da konac izlazi iz otvora gornjeg petljača
konca.
Kraj konca
Otvor gornjeg petljača
Ako konac ne izlazi iz otvora na petljaču, ponovite
postupak od koraka
NAPOMENA:
Podvucite 10 cm konca ispod stopice, i povucite
ga unazad između stopice i gornjeg noža.
Gornji nož
Vratite ručicu prekidača uvlakača donjeg konca na
poziciju "ŠIVENJE".
Ručica prekidača uvlakača donjeg konca
Zatvorite poklopac donjeg petljača i spustite
polugu stopice.
Summary of Contents for eXtend 864air
