21
⁄1
Raise the looper threader lever until it clicks into
place.
!6
Looper threader lever
!6
⁄1
!6
⁄2
!7
!8
!9
@1
@0
⁄3
⁄4
@2
⁄5
o
⁄2
Lower the looper threader lever until it knocks into
place.
⁄3
Make sure that the thread comes out from the hole of
the lower looper tip.
!7
Thread end
!8
Hole of lower looper tip
* If the thread does not come out from the hole,
follow the procedure from step
⁄1
again.
* If the thread comes out behind the pipe, use the
tweezers to draw the thread toward you between
the lower looper and the pipe.
!9
Thread (behind the pipe)
@0
Pipe
@1
Lower looper
⁄4
Draw 4˝ (10 cm) of the thread under the toe of the foot,
and pull it to the rear between the foot and the upper
knife.
@2
Upper knife
⁄5
Return the lower threader switch lever to the “SEWING”
position.
o
Lower threader switch lever
Close the looper cover and lower the presser foot
lifter.
Podignite polugu uvlaka
č
a donjeg konca sve dok ne
klikne na svoju poziciju.
Poluga uvlaka
č
a donjeg konca
Spustite polugu uvlaka
č
a donjeg konca sve dok ne
ulegne na svoju poziciju.
Uverite se da konac izlazi iz otvora na vrhu donjeg
Kraj konca
Otvor na vrhu donjeg petlja
č
a
petlja
č
a.
Ako konac ne izlazi iz otvora, ponovite celokupnu
proceduru uvla
č
enja od koraka
Ako konac izlazi iza cevi, upotrebite pincetu da ga
provu
č
ete ka sebi izme
đ
u donjeg petlja
č
a i cevi.
Konac (iza cevi)
Cev
Donji petlja
č
Izvucite 10cm konca ispod stopice i povucite ga od
pozadi izme
đ
u stopice i gornjeg noža.
Gornji nož
Vratite ru
č
icu prekida
č
a uvlaka
č
a donjeg konca na
poziciju "ŠIVENjE".
Ru
č
ica prekida
č
a uvlaka
č
a donjeg konca
Zatvorite poklopac donjeg petlja
č
a i spustite polugu
stopice.
Summary of Contents for eXtend 864air
