Maintenance and repair
32
BA/Elmaflame/GB/1107
© Elma GmbH & Co KG
4. Clean the glass as described above.
5. Remount the vapourizer glass by screwing the fastening
ring back to the right (
see illustration 8.1.3.E
.).
6. Fill the glass with vapourizer liquid as described in
section
8.1.2
.
Illustration 8.1.3. Vapourizer glass (A) with sintered piece (F) and
compensation tank (G) / dryer glass (C) with filter cartridge (B)
8.1.4
Cleaning of the dryer glass
Carefully read and observe the safety instructions in
section 8.1. (e.g. protection goggles and gloves) before you
carry out this maintenance work!
During operation, condensation water and entrained electrolyte
are separated in the dryer glass (
see illustration 8.1.3.C.
). If
there is more than 1 cm of condensate in the glass, remove the
condensate and rinse the glass with hot water subsequently.
For the disposal of electrolyte
see section 9.2.
1. Switch off the gas production at the
on/off
key
at the
operating panel.
2. Unscrew the fastening ring by turning it to the left (
see
illustration 8.1.3.D
.).
3. Remove the dryer glass. Move the complete top part
sideways to facilitate removal of the dryer glass.
4. Clean the glass as described above.
5. Remount the dryer glass by screwing the fastening ring
back to the right (
see illustration 8.1.3.E
.).
WARNING!
How to proceed
A
C
B
D
E
D
E
F
G
Summary of Contents for Elmaflame 140
Page 42: ......
