Necessary Procedures and Safety Warnings
Prior to Using
ThruScan
Avoid direct light from entering to the infrared sensors apertures
(see Sec. 6.10) of your
ThruScan
.
Leave minimum 1m between your
ThruScan
and any objects such
as metal doors, X-Rays, turnstiles, as such.
Do not place any covers, plating or loads that would induce weight
over your
ThruScan
unless being recommended by the factory.
Do not drill any holes on the panels of your
ThruScan
under any
circumstances.
Your
ThruScan
is secured both by a mechanical lock and an
electronic PIN CODE as a precaution towards unauthorized people.
Do not share your password. Contact factory when it is fogotten.
Assemble your
ThruScan
on a horizontal and flat floor. Make sure to
fix it firmly to the floor.
Do not assemble your
ThruScan
on a floor that is not rigid or stable.
Do not let unauthorized persons to interven
ThruScan
s electronic
units. Contact your dealer or the factory for authorized service staff.
Use soft, damp clothing to clean your
ThruScan
. Always unplug
your equipment during cleaning.
Never Operate! your equipment through mains without norm ground
ThruScan
is designed to operate between 70~270 VAC / 50Hz~60
Hz on a switching power unit. However you normally should operate
on 110-220VAC.
6
