28
1. Disconnect electrical supply to refrigerator.
2. Remove freezer section shelves and baskets.
3. Remove two screws securing ice cube tray holder
or ice maker (some models).
4. Disconnect ice maker molex plug from wiring harness
connector mounted on back freezer wall in upper left
hand corner (some models).
5. Remove fan access cover by pressing in on both
sides (top and bottom) of access cover and pull
forward.
6. Remove Light Shield by pressing in on tab on bottom
of shield and pulling forward. Remove light bulb.
7. Remove four screws securing evaporator coil cover.
8. Press in on tabs of wiring harness connector and
push through opening in fan access cover.
Figure C11
9. Disconnect four wires from evaporator fan motor.
(Green/Yellow, Red and two piggybacked Blue wires)
10.Disconnect three wires to lamp socket. (Yellow/Red
and two piggybacked Blue wires)
11.Remove Evaporator Coil Cover.
12.Remove two screws securing fan motor assembly
to evaporator coil cover.
13.Remove fan blade. (It pulls straight off.)
14.Remove two screws securing front motor bracket
to rear mounting bracket.
15.Check resistence of motor by reading across two
terminals on coil. Resistence should read high on
R1 scale. If not , replace motor.
16.Reverse procedure to complete repairs.
Summary of Contents for BEVERAGE CENTER II
