9
DOOR REMOVAL / REVERSAL INSTRUCTIONS
Door Stop
Screw
Center
Hinge
Screw
Bottom
Hinge
Screw
Top
Hinge
Screw
1.
Remove toe grille.
2.
Remove top hinge with 3/8” hex driver and lift freezer door off of center
hinge pin. Set door aside.
3.
Unscrew center hinge pin using adjustable wrench and save for
reassembly. Ensure plastic washer stays on hinge pin.
4.
Lift refrigerator door off of bottom hinge and set aside.
5.
Remove center hinge and shim by removing inside screw and
loosening two outside screws enough to allow hinge and shim to slide out.
Tighten screws.
6.
Loosen two outside screws on opposite side of refrigerator, remove inside
screw and install center hinge.
7.
Remove two screws on bottom hinge with 3/8” socket wrench.
8.
Install bottom hinge on opposite side with the two screws removed from
step 7.
9.
Unscrew bottom hinge pin using adjustable wrench. Move hinge pin to
other hole in hinge and tighten with adjustable wrench.
10. Move beverage center door stops to opposite side. Before starting screws,
use an awl to puncture the foam.
11. Position beverage center door onto bottom hinge pin and screw center
hinge pin through center hinge into top of door. Close beverage center
door to help align hinge hole.
12. Tighten center hinge pin with adjustable wrench.
13. Remove cabinet and hinge hole plugs and move to opposite side.
14. Lower freezer door onto center hinge pin.
15. Close freezer door. Have an assistant lift up on opposite side of door while
tightening screws to install top hinge.
16. Replace toe grille.
17. Plug in electrical power cord and turn beverage center temperature
control to the “5” position. Adjust setting as necessary.
DOOR REMOVAL AND REVERSAL INSTRUCTIONS:
Hinge
Hole Plug
Cabinet
Hole Plugs
Screws
Top Hinge
Shim
Hinge Pin
Washer
Center
Hinge
Screws
Door
Stop
Door Stop
Screw
Hinge
Hole Plug
Handle
Hole Plugs
NOTE
NOTE
NOTE
NOTE
NOTE
The direction in which your beverage center doors open (door swing) can be
reversed, from left to right or right to left, by moving the door hinges from one
side to the other. Reversing the door swing should be performed by a
qualified person.
IMPOR
IMPOR
IMPOR
IMPOR
IMPORT
T
T
T
TANT
ANT
ANT
ANT
ANT
Before you begin, turn the beverage center temperature control to “0” and
remove the electrical power cord from the wall outlet. Remove any food from
door shelves.
Summary of Contents for BEVERAGE CENTER II
