Electrolux 5995502399, Service Manual, Page: 104 / 173

6-4
Component Teardown
Control Removal
(Non-Dispenser Models Only)
To replace the user interface on non-dispenser models:
1. Open the left food door.
2. Place a putty knife between the top of the IQ touch
control and the door panel. Use the putty knife to
slide the top of the control out of the door panel.
(See Figure 6-7)
3. Slide the control out from the top and lift it out of the
door.
4. Disconnect the single harness connector at the top
of the control board. (See Figure 6-8)
5. With the control out of the door you can now remove
the board from the touch control. Disconnect the
ribbon connector at the bottom of the control.
(See Figure 6-9)
6. Push out on the 6 retainer tabs, one at a time,
starting from the bottom of the board and lift the
board up past the retainer. This will allow removal of
the control board from the touch panel.
To reassemble:
1. Place the board over the touch control housing.
Press the board past the retainers, one at a time,
starting at the top.
2. Reconnect the ribbon connector.
3. Reconnect the door harness to the board.
4. Place bottom of board into the housing in the door.
NOTE: Use caution not to damage the ribbon connector.
5. Push the control into place starting at the bottom and
working
up.
When handling and or replacing a control board it
is important the a technician have a wrist ground
strap on and connected to the cabinet or another
grounding position to prevent static electricity
from damaging the board.
Before servicing any part of the control system,
the product must be unplugged, the fuse pulled or
circuit breaker turned off to prevent damage to
the product control system or personal injury to
the servicer.
Figure 6-7.
Figure 6-9.
Figure 6-8.
Insert Putty Knife
Disconnect
Disconnect