Eldes EPIR2, Manual

Page: 45 / 64

45 45
EPIR2 User Manual v.1.4
5. ADDITIONAL INFORMATION FOR ADVANCED USERS
This section contains the wiring diagrams and other system features, such as remote configura-
tion via GPRS network connection and firmware upgrade procedure.
Your EPIR2 system comes equipped with wired zone and output terminals, therefore you may
wish to connect a wired sensor, wired siren or a LED indicator to your EPIR2.
The wired output can be used for wired siren connection or for system condition indication, while
the wired zone is intended for one wired sensor connection.
5.1. How to connect a wired siren or a LED indicator to the wired output
The output can be set to operate either as a siren output leading the connected wired siren activa-
tion in case of alarm or for showing the following system conditions by a connected LED indicator:
• NO SIM Inserted - SIM card not present. The LED indicator will flash if the SIM card is not
present in the EPIR2.
• SIM PIN Enabled - PIN code left enabled. The LED indicator will flash with pauses if the PIN
code is not disabled on the SIM card that is inserted in the EPIR2.
• GSM Operator Error - GSM connection error. The LED indicator will flash with pauses in
case of this error.
• Exit/Entry Delay - Exit and entry delay time-out. The LED indicator will flash during count-
down of exit and entry delay time-out.
• Zone Z1 Violated - Zone Z1 violation. When PIR detector’s zone Z1 is violated, the LED
indicator will illuminate and turn OFF when the detector’s zone Z1 is restored.
• Alarm - System alarm. The LED indicator will turn ON in case of alarm and turn OFF when
the alarm ends.
• System Armed - System armed or disarmed. LED indicator will be illuminated once the sys-
tem is armed and turned OFF once the system is disarmed.
Wired siren/bell
1. Remove the terminal block from the slot.
61